Section 11-610. MANUFACTURING AND PROCESSING (CR)

 

610.1Use for light manufacturing, processing, fabricating, or milling shall be permitted as in a CR District as a special exception when authorized by the Board of Zoning Adjustment under § 3104, if the Board considers that this use is appropriate in furthering the objectives of the CR Districts, subject to the provisions of this section.

 

610.2Use for light manufacturing, processing, fabricating, or milling shall comply with the standards of external effects for C-M Districts contained in § 804 and, further, shall have no adverse effects on other uses on the same or adjoining properties.

 

610.3Use for light manufacturing, processing, fabricating, or milling shall not result in dangerous or otherwise objectionable traffic conditions.

 

610.4There shall be adequate off-street parking for trucks and other service vehicles.

 

610.5There shall be no outdoor storage of materials.

 

610.6The Board may impose requirements pertaining to design, appearance, or screening, or any other requirements that it deems necessary for the protection of neighboring or adjacent property.

 

610.7Before taking final action on an application for use for light manufacturing, processing, fabricating, or milling, the Board shall refer the application to the D.C. Office of Planning for coordination, review, and report.

 

610.8The report of the D.C. Office of Planning shall include the reports and recommendations of the D.C. Department of Transportation, and other District departments and agencies as appropriate.

 

source

§ 4502.35 of the Zoning Regulations, effective May 12, 1958; as amended by Final Rulemaking published at 47 DCR 9741-43 (December 8, 2000), incorporating by reference the text of Proposed Rulemaking published at 47 DCR 8335, 8382 (October 20, 2000).