D.C. Municipal Regulations (Last Updated: September 13, 2017) |
Title 20. ENVIRONMENT |
Chapter 20-33. REGULATION OF LEAD-BASED PAINT ACTIVITIES |
Section 20-3304. PROHIBITED PRACTICES
-
3304.1The practices listed in this subsection are prohibited when performing any lead based paint activity or any renovation activity that disturbs presumed lead-based paint. No individual, firm or business entity shall use:
(a)Open flame burning or torching of paint;
(b)Machine sanding, planing, or grinding, or use of a needle gun to remove paint or other surface coatings, without a high-efficiency particulate air (HEPA) local exhaust control and without a shroud or containment system that allows no visible dust or release of air to occur outside the shroud or containment system;
(c)Abrasive blasting, water blasting, or sandblasting without HEPA local exhaust control or an effective containment system;
(d)Heat guns operating at or above eleven hundred degrees Fahrenheit (1100°F) or charring the paint;
(e)Dry sanding or dry scraping, except:
(1)Dry scraping within one foot (1 ft.) of electrical outlets;
(2)Dry scraping in conjunction with heat guns operating below eleven hundred degrees Fahrenheit (1100°F); or
(3)Dry scraping when treating defective paint spots totaling no more than two square feet (2 sq. ft) in any one interior room or space;
(f)Methylene chloride;
(g)Stripping paint in a poorly ventilated space using a volatile stripper that is a hazardous substance as defined in 16 CFR § 1500.3, or any chemical that is a physical hazard or a health hazard; and
(h)Scraping, sanding, drilling into, cutting, or otherwise disturbing more than two square feet (2 sq. ft.) of paint in or on a residential property or a child occupied facility built before 1978 without the use of appropriate containment measures.
3304.2No individual, firm or business entity shall apply paint with a lead content of more than 0.009 percent (0.009%), in accordance with 16 CFR § 1303.1.